HomeAbout UsContact UsPicturesDo you need to have your chimney swept??


Fireplace and wood burning stove chimneys develop a coating of creosote inside the smoke chamber and flue system. This will become a fire hazard if not removed. Creosote will go through a chemical transformation if left undisturbed and become a thick shiny glazing that is very difficult to remove. It is in this state that it is most flammable. We call this condition third stagecreosote. Third stage creosote can not be removed with conventional cleaning methods such as wire brushing. It must be first treated with a chemical to change the molecular properties and then it can be removed. This will usually take two to three visits and can get expensive with the added cost of the chemicals used. Burning properly cured wood and having your fireplace and chimney serviced annually will go a long way towards preventing a third stage creosote buildup.

Oil burner chimneys can easily get clogged with soot. Oil is the dirtiest burning fuel and its products of combustion are very volatile and corrosive. Neglecting to clean your oil burner chimney can lead to several consequences. All masonry chimneys have a point at which the horizontal pipe from the oil burner meets the vertical chimney flue. Over time this area will fill with soot and clay from the lining. As the debris piles up and fills the horizontal pipe from the oil burner, it effectively reduces the amount of natural chimney draft reaching the appliance. Keep in mind that not only is the chimney responsible for pulling the fumes from the oil burner to the outside, but also to draw the required air to be used for combustion into the oil burner itself. So from the information gathered so far, you can deduce that if your chimney is partially blocked, less air will be pulled into the burner which can alter the ratio of air to fuel during combustion causing excessive soot production, and the extra soot will have a hard time getting out of the chimney due to the weaker flow characteristics of a poor draft. This extra soot falls down to the base of the chimney under its own weight and compounds the problem. The warning signs would be a dusting of soot near the base of the chimney or on the top of the burner and possibly an odor of fumes when the unit starts up. If ignored, this will lead to a puff back and carbon monoxide entry.

Gas burner chimneys also need to be cleaned and inspected regularly. It is a common misconception that since gas is a clean burning fuel, gas appliances do not require maintenance. Gas chimneys can be more dangerous that oil or wood chimneys if not maintained. Many gas chimneys do not have protective caps installed. This can allow birds and squirrels, or debris from overhanging trees to enter the flue. Others have old terra cotta linings which crack and flake causing a blockage. Some were used in the past to vent an appliance that uses a different fuel type and break down even faster when connected to a new gas unit feeding it with moisture laden gases. Any blockage in a gas chimney can cause deadly carbon monoxide fumes to enter the living area. The reason that this can be so dangerous is that carbon monoxide is undetectable by any of our senses. When gas is burned, three byproducts are produced; carbon monoxide, carbon dioxide, and water vapor. In comparison, burning oil produces many aromatic hydrocarbons which you would notice, and promptly evacuate the area. Gas gives no such warning and this is why many lives are claimed without the victims ever knowing what happened.  

WHAT CHIMNEYS NEED TO BE SWEPT??
978-297-2263